Disassemble The Hpa Regulator In A Crossfire

The HPA regulator is situated directly while watching CO2 tank.

The HPA regulator is negligence a paintball gun which releases a precisely measured burst of propellant whenever you pull the trigger. Within the Crossfire paintball gun, it's situated between your CO2 tank and also the firing chamber from the gun. The HPA regulator can be taken off in the tank and taken apart utilizing a couple of common tools.

Instructions

1. Purge the tank of pressure by pressing the flat finish of the nail in to the pin from the outlet valve until gas stops getting away.

2. Warmth the collar which connects the HPA regulator towards the tank utilizing a warmth gun or hair dryer. This can melt the thread-securing compound which supports the regulator and tank together. Wrap a bit of rubber round the valve and twist them back using vice grips.

3. Boil a little pot water. The moment it begins to boil, take it out of warmth. Contain the HPA regulator within the warm water for 2 to 3 minutes.

4. Wrap a bit of rubber around the hex set up at one finish from the regulator and clap it firmly inside a bench vice. Wrap another bit of rubber round the top 1 / 2 of the regulator. Twist the 2 halves apart using vice grips.

5. Pull the 2 halves apart carefully, and empty the constituents out onto a obvious work area.