Fix A Lancer Paintball Gun

The Lancer paintball gun uses compressed air to pressure a paintball capsule in the magazine clip in to the firing chamber. The vertical loading mechanism may cause the paintball capsule to obtain lodged in to the front from the spring that propels it from the barrel. This renders the Lancer useless. Fixing the Lancer to ensure that it may again be utilized needs a partial disassembly to get rid of the paintball capsule from within the gun. The process won't void any warranty, because the manufacturer needs the Lancer to become periodically taken apart for maintenance and cleaning.

Instructions

1. Convey a soft cloth on the table. Take away the magazine clip from the foot of the Lancer paintball gun's handle. Put the gun around the soft cloth using the barrel facing left.

2. Take away the securing pin from the back side from the gun together with your fingers--the pin is simply underneath the hammer. Carefully pull the firing set up tube from the back from the gun. Put the firing set up tube around the soft cloth.

3. Pull the firing pin that's adhering from the back finish from the gun gradually right. Stop tugging once the spring that's connected to the finish from the firing pin is visible.

4. Grab your hands on the spring together with your hands. Pull the spring gradually from the back finish from the gun. Take away the firing pin in the right finish from the spring.

5. Put the spring around the soft cloth using the paintball capsule that's stuck towards the spring facing left. Place the edge of the flat-edged screwdriver in to the spiral from the spring just behind the paintball capsule. Push the end from the flat-edged screwdriver toward the left to push the paintball capsule out of the finish from the spring. Get rid of the paintball capsule within the trash.

6. Stand the spring around the soft cloth using the finish which had the paintball capsule mounted on it facing up. Put your palm against the top spring. Press lower around the spring to compress it. Contain the spring lower for any minute.

7. Put the spring into the back finish from the gun. Put the firing pin into the back finish from the gun. Put the firing set up tube into the back finish from the gun. Push the securing pin back with the hole. Pound around the securing pin two times using the handle from the flat-edged screwdriver to secure the pin towards the gun's frame. Put the magazine clip into the handle from the gun.