Make A Nerf Grenade Launcher

Create a homemade nerf grenade launcher utilizing a 1-inch wide spring 8 inches lengthy.

A homemade Nerf grenade launcher is comparable to a potato launcher with no official overflowing trigger. The trigger is made of an easy item like a paper clip. The paper clip supports the spring in position just before discharge of the grenade. A plastic film situation from the roll of film supports the spring in position and it is the best size to shoot a lot of money of Nerf grenades or bullets 1/2 by 3 inches lengthy. Create a homemade Nerf grenade launcher in roughly fifteen minutes in the end supplies are collected.

Instructions

1. Open the lid towards the plastic film container. Set the lid aside. Put the 1-inch spring within the container. Compress the spring so far as it'll go. Mark the top compressed spring around the outdoors from the container. Make two marks, one directly across in the other. Permit the spring to decompress and take it out of the plastic film container.

2. Cut a little hole around the mark around the outdoors from the film container. Place the purpose of the craft knife around the mark. Rotate the craft knife to drill an opening with the side from the container big enough therefore the wire from the large paperclip fits with the hole. Do this again around the second mark.

3. Open on several levels on the size of a sizable paperclip and straighten the wire. Bend the wire so it's in a 90-degree position just over the remaining on several levels. Put the straight finish from the bent paperclip with the two holes around the film container. This is actually the trigger towards the grenade launcher.

4. Take away the paperclip trigger and put the spring within the film container. Compress the spring and place the paperclip trigger with the holes. Check to make certain the paperclip reaches the best level to carry the spring in position. Adjust the holes if required.

5. Carefully take away the paperclip trigger and spring in the plastic film container. Squeeze enough hot glue to pay for the foot of the film container. Immediately switch the spring within the container. Lightly push the top spring to sink the foot of the spring within the hot glue. Put aside and let dry for five minutes.

6. Cut a 1-to-1 1/2-inch bit of duct tape. Turn the tape therefore the sticky side expires. Place the tape between the foremost and second coil from the spring. Switch the perimeters from the tape up and outrageous spring encasing it in duct tape. Cut any corners in the tape therefore the spring fits easily in to the film container.

7. Compress the spring and secure using the paperclip trigger. Put the heavy-duty rubberband around the top film container so half is around the container and also the partner is over the lid line.

8. Stack three Nerf grenades together by means of a pyramid. Secure the Nerf grenades along with three rubber bands. Place one rubberband in the centre and something 1/4 inch from each finish.

9. Stand the Nerf grenades up so that they are located on finish. Place the finish within the rubberband until it's sitting on the top from the spring. Point the Nerf grenade in the preferred target. Pull the pin in the side from the container. The Nerf grenades will launch.